BEll
calls Sysop (about 10 sec intermitting beep).
Bye/Quit
BBS carries out Disconnect.
Check
lists the latest BBS files.
Without parameter: 10 info files are listed.
Parameter: P (=PRIVATE) -> personal MSGs are listed.
Additional Parameter: 1..100 -> determines number of files to be listed.
eg: CH P 30 <Enter> lists latest 30 private MSGs.
DAte
tells you the actual PTC date.
Dir
shows the contents of the BBS main directory.
Every entry in the main directory is the name of a sub-directory.
You can list the contents of every sub-directory by using Dir sub-directory
(name of sub-directory).
Also see List command.
Erase
allows you to delete one or more files.
Format: see Read command
Delete commands without filenumber are not possible.
Only files for you or from you can be deleted on the remote side of
the system.
Gate
this command controls the PR->PACTOR HF-Gateway.
Without argument: Shows the channel list.
With a target CALLSIGN as argument:
System tries to establish HF-Link on channels with CALLSIGN in the
comment field.
E.g.: G DL2FAK
If a channel number is appended to the CALLSIGN:
System tries to establish HF-Link on defined channel.
E.g.: G DL2FAK 22
Gateway connects are only possible on channels with enabled Gate-flag.
*** WARNING: YOUR CALLSIGN WILL APPEAR ON HF/SHORT
WAVE!
*** PLEASE DO NOT USE THE HF-GATE WITHOUT
HF-LICENSE!
Help
shows the list of possible commands.
If you type Help cmd (cmd is one specific command from the list), you
will get detailed help information about cmd (the contents of this current
page).
Most of the commands can be abbreviated by using only the first part
(marked as upper case letters or being outside of brackets).
List
shows the contents of any existing sub-directory.
Without argument the contents of the actual sub-directory (path) will
be listed.
LOg
lists the last 16 entries of the PTC user logbook.
The character in front of the call signs is defined as follows:
am=amtor-, p=pactor-, x=packet-access, s=sysop-call.
POSition
shows a GPS Position Report.
POS NMEA <Enter> shows an NMEA-compatible GPS sentence.
Quit /Bye
BBS carries out Disconnect.
Read
shows the contents of every existing file.
Format: Read filename filenumber
If you do not specify the filename, the actual sub-directory (path)
will be used instead of filename.
f you do not specify the filenumber, the first file will be read if
the sub-dir contains only a single file, otherwise the sub-dir will be
listed.
ou can read a list of files at once if you use extended filenumbers
like 1- or simply 3-5, etc.
Send / Write
initiates file writing.
Format: S filename [title of file] (title optional)
After getting back the keys, you can upload any text/7PLUS file.
Termination of file writing can be done either by performing a changeover
or typing control-z or nnnn (HF-Port) or ***end (PR-Ports) at the remote
side.
The Sysop can terminate file writing simply by typing the ESC-character
once.
The filename is interpreted as sub-dir name and (if required) a new
sub-dir will be generated.
*** This BBS is not doing any Store&Forward,
*** please do not use it for enterering messages
!
*** Next BBS with S&F is DB0LJ-8.
SHow
show the actual connect status
Parameters:
A (All) show all parameters
C (Characters) show the configured control-characters
P (Parameters) show the system parameters
Time
tells you the actual PTC time.
TRX
shows the HF channel list.
User
shows the actual user-list.
Version
shows the actual version number of the PTC firmware.